How To Reset Tpms On Hyundai Santa Fe

Some Hyundai vehicles are equipped with a tire pressure monitor that is connected to the on-board computer for the purpose of tracking changes in air pressure in the tires. Click the register link above to proceed.

How To Reset Tire Pressure Light Tpms Light On Or Blinking Auffenberg Dealer Group

If you live in the US take it to qany Auto Zone store and thy will read the codes off for you I would suspect any right thinking competitor would do the same check if you dont have one near by.

How to reset tpms on hyundai santa fe. Push down on the tire at the 3 oclock position and rotate the rim clockwise to fit the top bead. Press the TPMS reset button and hold it until the light blinks three times then release it. If the tires were rotated then they should have reset them at that time.

2019 Hyundai Santa Fe - TPMS Light. Tire Pressure popped up with a picture of a car pointing to the tires. Asked by Guru9ZDX6T Nov 25 2020 at 0339 AM about the 2019 Hyundai Santa Fe XL Limited Ultimate AWD Question type.

If there is a problem with the sensors it still should be under factory warranty so visit the dealership. Shut the car off for 3 -4 hours then check the gauge should be working now. Front left front right rear left then rear right.

1 Condition Ignition ON and Engine OFF. When the monitor determines that one or more of the tires is under-inflated a warning. Inflate all tires to the pressure listed on the vehicle placard.

2 Hold the TPMS module within 3 inches 76 mm of the sensor valve read each tire pressure sensor ID in the following order. 3 Press the ENTER button as each tire is illuminated on the screen. Mustangman October 31 2019 621pm 2.

Use the OBDII module to retrieve the Hyundai DTC TPMS information to diagnose and service the TPMS issues determined. The TPMS reset button is usually located under the steering wheel. Hyundai Santa Fe TPMS Relearn and Reset If this is your first visit to The TPMS Forum be sure to check out the FAQ by clicking the link above.

Check engine light illuminated 1004 Hyundai Santa Fe. Beep the horn 11 times 5. To reset the low tire pressure light on the Hyundai Santa Fe press and hold down the TPMS Reset button until you see the light blink 3 times then start the car and leave it.

Put on the the high beams 4. Put on emergency lights 3. Drive the car at 50 mph for about 10 minutes.

Start the car and let it run for 20 minutes to reset the sensor. Relearn Procedure when Replacing a Sensor. Starting with the LF tire use the scan tool to scan each sensor in the following order.

While car is on push the brake pedal 4 times slowly. Youll usually find the tire pressure monitor reset button beneath the steering wheel. Hope this is of some help.

If you cant find it consult your owners manual. Similarly how do you reset the TPMS on a Hyundai Santa Fe. Follow these directions.

Inflate the tire until both beads seat. Without starting the car turn the key to the On position. LF RF RR LR and full size spare if equipped.

I have a 2009 hyundai santa fe the tpms light is on i had it serviced at an authorized hyundai dealer they scantested system and programmed the tpms system and it appeared to be fixed untill i was on my way home and the light came back on. You may have to register before you can post. Turn ignition to the ON position with the engine OFF not the ACC position.

Press the TPMS reset button and hold it until the light blinks three times then release it. TPMS Reset Instruction. November 1 2019 1251pm 1.

Use the VT56 to retrieve Hyundai TPMS DTC codes by selecting the Service icon. If the TPMS indicator does not illuminate for 3 seconds when the ignition switch is turned to the ON position or engine is running or if it comes on after blinking for approximately one minute take your car to your nearest authorized HYUNDAI dealer and have the system checked. After selecting the Make Model and Year select the DTC code icon.

Start the car and allow 20 minutes to pass for the sensor to refresh. Anyway to answer your question you need a scan tool that can access the TPMS system and run the reset that is the safest way to do it. Start the car and let it run for 20 minutes to reset the sensor.

If you read. Hold the tire pressure monitor reset button until the TPMS light blinks three times then release it. Low tire pressure indicator.

Maintenance Repair Can not reset the TPMS on a 2020 Santa Fe Ultimate. 1 people found this helpful. Check your users manual if youre having trouble locating it.

After bottom bead is on tire rotate the rim until the sensor is at the 5 oclock position relative to the head on the tire changing machine.

Hyundai Archives Let S Fix That Car